Converting using UFS Twister
some screenshots flashing the x426…


after flashing,you will have a "HONGKONG GPRS" at start up,if it’s not yet set into an english language,go to settings,than press 5,then set it to english language,then MASTER RESET it to let your keypads to have light.or you can simply click "reset mmi"
after that you open the back panel of your X426/X427 phone…
you will now see the antenna switch,simply remove the shield carefully & put a jumper wire like this on my attached imaged…

after you follow these steps…you will now have a working X426/X427 phone…not only that but you will also have 1800MHZ working band,of course the 900mhz band.tried & tested(TODAY )
All comments are moderated. Your comments will not appear here unless approved by the blog owner. Thank you.